An Edge Flange feature can set the shape and size of the relief at the corners its flanges make, in place of the sheet metal rule's. Design format 24.
Co-authored-by: NOWN-DEV <[email protected]>
Co-Authored-By: Claude Sonnet 5.5 <[email protected]>
Converted sheets take the rule's corner relief between walls and its bend relief where a bend ends beside more of the fixed face, and a wall on part of an edge bends only where it stands. Noted under format 21; nothing new is saved.
A Convert to Sheet Metal bend point can now lie on a bend modelled with its radius (a cylinder tangent to two flat faces) or in the middle of a chamfer; either becomes one bend at the faces' virtual sharp, with the rule's radius. Holes and engravings carry over. Bend points on edges convert as before. Recorded under format 21. Tests in cmd::sheet::convert_tests; the sheet-metal guide is updated.
Convert to Sheet Metal now takes a solid or a shelled body by its bend edges (`bends`): the faces reached from the fixed face across those edges become the sheet, keeping the part's envelope, with the flat pattern by the rule's K-factor and radius. Other edges between sheet faces are cut open. The result works with edge flanges, cuts, Unfold/Refold, the flat pattern and DXF. A conversion without `bends` is the plate conversion as before. The optional `bends` field is noted under format 17. Fixes#647.
Co-Authored-By: Claude Opus 5.5 <[email protected]>
