Chamfer is one of the most common features and is usually applied right
after a cut. A chamfer cuts with a prism cutter, and its history came out
None after four of the six common box cuts. Without exact history, any
reference to a chamfer face (or a face it trimmed) falls back to geometric
guessing in naming, which can silently re-attach to the wrong face.
Two gaps in the stepped-prism section tags caused it, both now closed by
bookkeeping at construction, never by sampling or geometric tie-breaks:
- Cap edge at the far end of a slab. A slab's section is read off the cap
where it starts and carried up to the cap where it ends; that cap's
outline can run along one wall in several collinear edges, so which one
a result edge lies on was unknown. When the stack is read, each slab
segment that runs end to end along one segment of an ending cap's
outline (beside the same wall) records that cap edge as `far`; the
lineage takes it when it bounds the wall and the result cap.
- Walls an earlier cut left in coplanar pieces. A segment carried through
a level kept the wall it was read beside, even where that wall gives
way to another piece at the level (or within the slab), so the tag named
the wrong face. `Stations` records the operand's edges across walls;
at each level a carried segment keeps its wall when nothing crosses it
there, moves to the one wall across it when it ends there, and is
otherwise unknown (no history). A wall crossed inside a slab is unknown
too, for simple and stepped prisms alike.
chamfer_after_box_cuts now covers all six cuts (notch, pocket, step,
slot, hole, bite), each verified against geometry and composed through
the cut over [block, tool]. The layered partial-depth cut test now
verifies its second cut, whose history was None before.
Co-Authored-By: Claude Opus 5.5 <[email protected]>
Claude-Session: https://claude.ai/code/session_01J53sR6gEaVt56soFDpTck8
